Installation Instructions

Document No. 129-703
Installation Instructions
May 10, 2016
Siemens Industry, Inc. Page 3 of 7
Mounting and Wiring the Terminal Block
Assembly
1. Mount the Drive Adapter Plate re-using two of
the four drive mounting screws from previous
step (mounted at the top of the plate only). See
Figure 8 and Figure 9.
Figure 8. Drive Adapter Plate with Proper Alignment.
Figure 9. Drive Adapter Plate, Secured.
2. Slide in the Drive Enclosure Bracket. Use a
large Phillips screwdriver and the remaining two
drive mounting screws to secure in place. See
Figure 10 and Figure 11.
Figure 10. Drive Enclosure Bracket.
Figure 11. Finished Assembly.
NOTE: The front face of the Drive Enclosure
Bracket must align with the bottom
edge of the Drive Adapter Plate.
3. Install the pre-wired terminal block assembly
onto the Drive Enclosure Bracket studs, with
wires facing up.
Figure 12. Terminal Block Assembly.
4. Secure with 10-32 nuts (included in hardware
kit).
5. Separate the ground wire from its harness, if
required.
Figure 13. Ground Wire.