Installation Instructions

Document No. 129-703
Installation Instructions
May 10, 2016
Page 2 of 7 Siemens Industry, Inc.
Installation
Removing the SED2 Drive
1. Disconnect power.
WARNING:
Always wait five minutes after disconnecting the
SED2 from the power source before performing
any work.
2. Open Bypass door and remove SED2 terminal
strip cover and Drive Protective Cover.
Figure 3. SED2 Terminal Strip Cover and Protective
Cover.
Figure 4. SED2 Drive with Covers Removed.
3. Using a small flat-blade screwdriver and small
Phillips screwdriver, disconnect input, output,
ground conductor, and control wiring from
existing SED2 Drive.
Figure 5. SED2 Drive with Wiring Removed.
4. Using a large Phillips screwdriver, remove the
drive mounting screws (save for re-use) and
remove the SED2 Drive and protective shield
from the backplane.
Figure 6. SED2 Drive Mounting Screws Location.
Figure 7. Backplane with SED2 Drive and Protective
Shield Removed.
NOTE: Dispose of electronic materials properly.