Installation Instructions

Document No. 129-710
Installation Instructions
May 10, 2016
Page 8 of 10 Siemens Industry, Inc.
Figure 7. Conduit Fitting Installation (Typical).
6. Hang the BT300 Drive in place on the drive
adaptor plate. Use two of the hex nuts at the top
studs to hold the drive in place.
Figure 8. Drive Installation, Step 6.
7. Maneuver the gland plate in place while
positioning the drive in its final location.
Figure 9. Gland Plate Re-Installation.
8. Reattach the gland plate using the screws
removed in installation Step 4. Remove the hex
nuts at the top of the drive adaptor plate and
using the remaining hex nuts, lock washers and,
and washers, secure the BT300 Drive in place.
Figure 10. Complete the Drive Installation.
Installation of the BT300 Drive is now complete.