Installation Instructions

Document No. 129-710
Installation Instructions
May 10, 2016
Siemens Industries, Inc. Page 5 of 10
Figure 1. Removal of SED2 Keypad.
3. Using a T20 Torx, remove the right side cover
and bottom cover from the SED2 Drive.
Figure 2. Drive Right Side Cover.
Figure 3. Drive Bottom Cover.
4. Using a small flat-blade screwdriver, disconnect
the control wiring from the drive.
Figure 4. Control Wiring Removed.
5. Using a 13 mm socket, disconnect the input
power, output motor leads, and ground
conductor at the SED2 Drive terminals.
Figure 5. Power, Motor, and Ground Wire
Removed.
6. Open the bypass door and pull the wiring down
through the conduits into the cabinet.
7. Remove the conduits nuts from the fittings inside
the bypass enclosure.
Figure 6. Conduit Lock Nuts (Typical).
8. Using a No. 2 Phillips screwdriver, remove the
drive mounting screws.
The SED2 Drive removal is now complete.