Installation Instructions

Document No. 129-710
Installation Instructions
May 10, 2016
Siemens Industries, Inc. Page 3 of 10
6. Using a small Phillips screwdriver, disconnect
the input power, output motor leads, and ground
conductor at the SED2 Drive terminals.
Figure 4. Power and Motor Leads Removed
(Frame Size A).
Figure 5. Power and Motor Leads Removed
(Frame Size B).
7. Open the bypass door and pull the wiring down
through the conduits into the cabinet.
8. Remove the conduit nuts from the fittings inside
the bypass enclosure.
Figure 6. Conduit Lock Nuts (Typical).
9. Using a No. 2 Phillips screwdriver, remove the
drive mounting screws.
Figure 7. Screw Removal (Frame Size A).
Figure 8. Drive Removal (Frame Size B).
10. Pull the drive and conduits outward and up away
from the enclosure back plane.
The SED2 Drive removal is now complete.