User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSED2 Advanced Operator Panel (AOP)

17/32

Siemens Building Technologies SED2 Advanced Operator Panel AOP CM1B5192en

HVAC Products Editing Parameters 19.01.2004

5.6 Copying Parameter Sets

Caution

Upload/Download Limitations:

With any of the software versions up to and including A03/1.45, SED2 VSD parameters

of access level 4 cannot be uploaded. With software versions A06/1.59 or higher, this

limitation no longer applies, that is, parameter sets of all four access levels can be

uploaded or downloaded, including all motor parameters.

Memory Limitation:

The delivered AOP supports five European languages: English, German, French,

Spanish, and Italian. Due to internal memory limitations, you should delete one of

these languages in order to upload the specified ten parameter sets that can be

held on the AOP.

To Delete a Language:

Select LANGUAGE from the main menu, highlight the language you want to delete, and

then press

and .

Note: Once a language has been removed, it cannot be restored.

5.6.1 Parameter Upload (Upread)

The upload/upread procedure reads a parameter set from a SED2 VSD and stores that parameter set in the

internal memory of the AOP. The AOP can read from a single SED2 VSD in LOCAL mode or from one specific

SED2 VSD on a network of SED2 VSDs in MASTER mode.

Use the following procedure to upload/upread a parameter set from a SED2 to the AOP:

1. From the main menu, use

and to scroll through the list of options and to highlight the UPREAD item.

Press

to confirm the selection. Press to cancel the upload process.

The AOP displays an UPLOAD / UPREAD menu.

Note: In MASTER mode, the AOP prompts for selection of a specific SED2 VSD from a list of the net-

worked SED2 VSDs.

2. Use

and to scroll through the list of parameter sets and to highlight the parameter set into which

information will be written.

Press

to confirm the selection.

Notes: If the selected parameter set already contains information, the AOP prompts to clear the existing

parameter set.

Simultaneously press

and when uploading to delete the existing parameter set.

When viewing stored parameter sets, press

and

to display the software version number of

the uploaded parameter set.

3. The AOP prompts for confirmation.

Press

to confirm the process. Press to cancel the upload process.

4. The AOP displays a wait screen while the upload process occurs.

5. On completion of the upload process, the AOP returns to the main menu.