User Manual

15/32
Siemens Building Technologies SED2 Advanced Operator Panel AOP CM1B5192en
HVAC Products Editing Parameters 19.01.2004
TIP: How to quickly change parameter values?
To quickly change a parameter value, use the following procedure to change the single digits of the display:
1. Press and the right-hand digit blinks.
2. Press or to change the value of this digit.
3. Press again and the next digit blinks.
4. Perform Steps 2 and 3 until the desired value displays.
5. Press to exit the parameter value
Note:
Simultaneously press and , at any time, to return to the main menu
Simultaneously press
and , at any time, to display the parameter help screens.
5.3 Editing Indexed Parameters
Use the following procedure to view and edit parameters with indexes.
1. Make certain you are in the expert access level (P0003=3).
2. From the main menu, use
and to scroll through the list of options and to highlight the PARAME-
TERS item.
Press
to confirm the selection.
The AOP displays a parameter screen so you can select the desired parameter group or access level.
3. Use
and to scroll through the groups/access levels and to highlight the desired parameter group.
Press
to confirm the selection?
When you select a parameter group, the AOP displays the first parameter in ascending numerical order.
4. Use
and to scroll through the list of parameters and to highlight the desired parameter. Press to
confirm the parameter selection.
5. Press
again to access the parameter index. Use and to scroll through the indexes and to high-
light the desired index.
6. Press
to access the index value. Use and to scroll through the index values and to highlight the
desired index value.
7. Press
to confirm the new index value. The AOP returns to the parameter selection screen so you can
select another parameter, if desired.
8. To edit another indexed parameter, repeat Steps 3 to 6.
5.4 AOP Stored Parameter Sets
The AOP contains a battery-backed storage facility for storing up to 10 parameter sets that are identified nu-
merically from 00 to 09.
Only a parameter set containing parameter data can be edited. If the selected parameter set does not contain
parameter data, the AOP asks if the default parameter set should be copied to the selected parameter set.
When you confirm this request, the AOP copies only the editable parameters to the selected parameter set;
read-only parameters are accessed from the original parameter location.