User manual

44 SPARC Enterprise T1000 Server Administration Guide • April 2007
3. Verify that the member disks are available and that there is not a volume already
created. using the raidctl command:
The server’s on-board SAS controller can configure one RAID volume. Prior to
volume creation, ensure that the member disks are available and that there is not a
volume already created.
See “Physical Disk Slot Numbers, Physical Device Names, and Logical Device
Names for Non-RAID Disks” on page 42.
The preceding example indicates that no RAID volume exists. In another example, a
single IM volume has been enabled. It is fully synchronized and is online:
# raidctl
No RAID volumes found.
# raidctl
RAID Volume RAID RAID Disk
Volume Type Status Disk Status
------------------------------------------------------
c0t0d0 IM OK c0t0d0 OK
c0t1d0 OK