User manual

34 SPARC Enterprise T1000 Server Administration Guide • April 2007
▼ To Enable Automatic System Recovery
1. At the sc> prompt, type:
2. At the ok prompt, type:
Note – For more information about OpenBoot configuration variables, refer to the
SPARC Enterprise T1000 Server Service Manual.
3. To cause the parameter changes to take effect, type:
The system permanently stores the parameter changes and boots automatically
when the OpenBoot configuration variable auto-boot? is set to true (its default
value).
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.
▼ To Disable Automatic System Recovery
1. At the ok prompt, type:
2. To cause the parameter changes to take effect, type:
The system permanently stores the parameter change.
sc> setsc diag-mode normal
sc> setsc diag-level max
sc> setsc diag-trigger power-on-reset
ok setenv auto-boot true
ok setenv auto-boot-on-error? true
ok reset-all
ok setenv auto-boot-on-error? false
ok reset-all