User manual

8 SPARC Enterprise T1000 Server Administration Guide • April 2007
■ If your network uses static IP addresses, type:
■ If your network uses Dynamic Host Configuration Protocol (DHCP), type:
4. Type one of the following commands:
■ If you intend to use Secure Shell (SSH) to connect to ALOM CMT:
■ - If you intend to use Telnet to connect to ALOM CMT:
5. Reset the system controller so that the new settings take affect:
6. After the system controller resets, log in to the system controller and issue the
shownetwork command to verify network settings:
To connect through the network management port, use the telnet or ssh (based on
the value you provided in Step 4) commands to the IP address you specified in
Step 3 of the preceding procedure.
sc> setsc netsc_dhcp false
sc> setsc netsc_ipaddr ip-address
sc> setsc netsc_ipnetmask ip-netmask
sc> setsc netsc_ipgateway ip-address
sc> setsc netsc_dhcp true
sc> setsc if_connection ssh
sc> setsc if_connection telnet
sc> resetsc
sc> shownetwork