Operating instructions

Assembly
4.2 Installation on a DIN rail
SCALANCE X-100
28 Operating Instructions, 07/2014, A2B00060666-05
4.2
Installation on a DIN rail
Installation
To install the device on a 35 mm DIN rail complying with DIN EN 50022, follow the steps
below:
1. Place the second housing guide of the device on the top edge of the DIN rail.
2. Press the device down against the DIN rail until the spring catch locks in place.
3. Fit the connectors for the power supply. See also section "Power supply (Page 33)".
4. Fit the connectors for the signaling contacts. See also section "Signaling contacts
(Page 35)".
5. Insert the terminal blocks into the sockets on the device.
WARNING
Use of the SCALANCE X108PoE in shipbuilding
When used in shipbuilding, mounting the SCALANCE X108PoE on 35 mm DIN rails is
not permitted.
35 mm DIN rails do not ensure sufficient stability when used in shipbuilding.
Figure 4-1 Installation on a 35 mm DIN rail