Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

Note: The letter X represents the box number, a comma (,) represents a pause,

and an exclamation point (!) represents a hookflash. For example, if the Lite

system needs to dial the extension number, then hookflash and dial 44 to

turn on a message waiting lamp, this field should read: !,44

8. Press <Enter> to move the cursor to the SEQUENCE TO TURN OFF MESSAGE WAITING

LAMP field. The entries displayed in this field were set during program setup and should

be sufficient. Review the settings shown, and make any changes you feel are necessary.

For details, refer to the phone documentation and technical bulletin for the phone system.

9. Press <F9> to move to page 2 of the Mail Box setup screen.

10. Press <Enter> to move the cursor to the AFTER PLAYING GREETING field. Verify this

field is set to Wait For A Digit.

11. To save the prototype mailbox setup you specified and exit the setup screens, press

<F10>. The program displays the Box Information menu.

2.5.6.6 Creating Subscriber Mailboxes

Once you set up Prototype mailbox 9994, you can now efficiently set up all the mailboxes

that will be used by subscribers on the system.

1. From the Box Information menu, select MAIL BOX. The Mail Box setup screen displays.

2. To add a new mailbox, press <F2>.

3. A small window displays prompting you for the box number. Enter the number of the

first mailbox you want to create, then press <Enter>.

Note: Enter as the mailbox number the same number as the extension to which

the mailbox will transfer calls. Also, note that the default password for each

mailbox is the same as the box number.

4. The Lite system creates the new mailbox by making a copy of the Prototype mailbox.

The new mailbox is displayed on the screen.