Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

18. The Install program must reboot the Lite system unit to make the changes indicated.

Press <Y> when the system displays the reboot prompt. After the system reboots, the

Line Status screen displays.

2.5.5 Specifying System Information

System Information screens contain system setup information that applies system-wide, to all

boxes set up on the system. There are six System Information screens:

• General Information Screen

• Line Information Screen

• Business Hours Screen

• Call Transfer Screen

• Class of Service Screen(s)

• Other Customizations Screen

Before you set up Routing boxes and mailboxes, it is best to ensure all System Information

screens are properly completed.

Note: Because the default information on System Information screens is set so the

Lite system is operational with as few changes as possible, the procedures

provided in this document for entering data on System Information screens

do not go into detail about all the screen entries. Instead, the procedures

guide you through accessing and reviewing pertinent fields on certain

screens, so you can verify that default data is properly set and modify it if

absolutely necessary. If you need to make additional changes to the System

Information screens, refer to information provided in the Installation and

Maintenance Manual.

Note that you can access online help at any time by pressing <F1>.

2.5.5.1 Integration Defaults Set by the Integration Program

When you run the PBX Setup utility (previous procedure), you are prompted to indicate the

type of telephone system the customer is using. If you are installing the Lite system on one