Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

2.5 Setting Up the System by Attaching a Laptop

Use the information in this section to complete all necessary system setup steps by attaching a

laptop computer to the Lite system unit and using the Lite system’s screen interface to run the

PBX Setup utility and to complete System Information and Box Setup screens.

2.5.1 Installing KeyLink Software onto the Laptop

1. Insert the KeyLink diskette into the diskette drive on the laptop computer. Change to the

diskette drive by typing A: then pressing <Enter> (where A is the drive letter for the

diskette drive).

2. To start the installation process, type INSTALL then press <Enter>. The KeyLink

remote system communication program creates the \KEYLINK directory on the laptop’s

hard drive, then copies the KeyLink remote system communication program to that

directory. (The KeyLink host system communication program is pre-loaded on the Lite

system.)

3. When all the necessary files have been copied to the \KEYLINK directory, a message

displays indicating the installation is complete.

2.5.2 Connecting the Laptop to the Lite System Unit

You connect the Lite system unit to the laptop computer using a null modem serial cable.

When you install KeyLink software on the laptop computer, the program defaults to using the

COM 1 port on the laptop. Therefore, unless you change this default, you should connect one

end of the null modem serial cable to the laptop’s COM 1 port. Attach the other end of null

modem cable to the COM 2 port if you are using the Small Office Lite system unit or the

COM 1 port if you are using the Debut system.

Establishing a Communication Link Between the Laptop and Lite System Unit:

1. To access the Lite system program screens from the laptop PC, change to the \KEYLINK

directory, then type REMOTE and press <Enter>.