Installation manual

LITE SYSTEM INSTALLATION AND SUPERVISOR GUIDE 9.0 VER. 1

Each line to the Lite system unit requires an industry-standard-telephone port on the PBX

(this is also known by other names such as analog port, 2500 set interface, SLT port.). Some

telephone systems do not provide single-line-telephone ports, and they require a special

analog interface box between the PBX and the voice-mail system, as shown below. If in

doubt, contact the local PBX manufacturer’s representative.

Line 1

Line 2

PBX

Line n

Voice-processing board

CO 1

CO 2

CO n

Normal PBX extensions

Central

Office

A T I

Ext A

Ext B

(

Radio-shack part

number 279-402

Connecting the Lite System to a PBX via External Analog Telephone Interface (ATI) Equipment

Connecting the Serial Cable Between the Lite System Unit and PBX

If you are establishing a serial integration, you must attach a serial cable between the Lite

system unit and the PBX. The Lite system unit is set up to use the COM 1 port to

communicate with the phone system. Therefore, you should connect the serial cable to the

Lite system unit’s COM 1 port.

Consult the phone system documentation for instructions on attaching the serial cable to the

phone system COM port.

Note: If the phone system you are working with is a Comdial DSU (Impression 24,

48, 72), attach the serial cable to COM 1 on the DSU. If the phone system is

a DSUII (Impact 24, 48, 72), attach the serial cable to COM 3 on the DSUII.