Specifications

28
Appendix
Gigaset S68H / IM1 - en / A31008-M1950-R101-1-4N19 / main.fm / 6.2.08
Version 4, 16.09.2005
Questions and answers
If you have any questions about using
your handset, visit us at any time at
www.siemens.com/gigasetcustomercare
.
The table below contains a list of common
problems and possible solutions.
Authorisation
This device is intended for use within the
European Economic Area and Switzerland.
If used in other countries, it must first be
approved nationally in the country in
question.
Country-specific requirements have been
taken into consideration.
We, Siemens Home and Office
Communication Devices GmbH & Co. KG,
declare that this device meets the
essential requirements and other relevant
regulations laid down in Directive 1999/5/
EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
http://www.siemens.com/gigasetdocs
.
Bluetooth
ò
Qualified Design Identity
The Bluetooth QD ID for your Gigaset S68H
is: B012741.
Registration or connection problems with a
Bluetooth headset.
¥ Reset the Bluetooth headset (see the user
guide for your headset).
¥ Delete registration data from the handset
when deregistering the device
(see page 26).
¥ Repeat the registration process
(see page 25).
The display is blank.
1. The handset is not turned on.
¥ Press and hold the end call key a.
2. The battery is flat.
¥ Charge or replace the batteries (page 6).
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥ Press and hold the hash key
#
(page 9).
"Base station x" flashes on the display.
1. The handset is outside the range of the
base station.
¥ Move the handset closer to the base
station.
2. The handset has been deregistered.
¥ Register the handset (page 7).
3. The base station is not turned on.
¥ Check the base station mains adapter.
Base Search flashes in the display.
The handset is set to Best Base and no base
station is turned on or within range.
¥ Move the handset closer to the base
station.
¥ Check the base station mains adapter.
Handset does not ring.
The ringer tone is deactivated.
¥ Activate the ringer tone (page 21).
The other party cannot hear you.
You have pressed the
u (INT) key. The hand-
set is "muted".
¥ Switch on the microphone again (page 12).
You hear an error tone when keying an
input (a descending tone sequence).
Action has failed/invalid input.
¥ Repeat the operation.
Watch the display and refer to the user
guide if necessary.