Specifications

AT command set for S45 Siemens mobile phones and modems
_________________________________________________________________________________________
__________________________________________________________________________________________
Siemens Document No.: A30880-A10-A001-3-D376
Revision: 1.8
Revision Date: 30. November, 2001
98
2.4.2.28 AT^SRTC
AT^SRTC Set the ringing tone
Test command
AT^SRTC=?
Response
^SRTC: (list of supported <type>s), (list of supported <vol>s)
Parameter
<type>
1-X
Number of ringing tone
0 Mutes the ringing tone; when MTC is set, the phone
does not ring and the volume is ignored
<vol> 1-Y
Volume of ringing tone
Read command
AT^SRTC?
Response
^SRTC: <type>, <vol>, <ringing>
Parameter
<type>
See Test command
<vol>
See Test command
<ringing>
0 Test-ring is switched off
1 Test-ring is switched on
Write command
AT^SRTC=[<type>][,<vol>]
Parameter
<type>
See Test command
<vol>
See Test command
Response
OK/ERROR
Execute command
AT^SRTC
Response
The ringing tone sounds on the current NF device; it is selected using
”AT^SNFS” until AT^SRTC is called up again
OK/ERROR/+CME ERROR
Note: If an MTC arrives while the test-ring is active, the latter is switched
off and the ”normal” ring is switched on.
2.4.2.29 AT^SSTK
AT^SSTK SIM Toolkit
Test command
AT^SSTK=?
Response
^SSTK: <profile>
Parameter:
<profile>
ME profile according to GSM 11.14
Write command
AT^SSTK=<length>[,<mode>]<CR>
PDU is given:
<ctrl-Z/ESC>
Response:
OK/ERROR/+CME ERROR
Parameter:
<length>
Length of PDU in bytes
<mode>
0
Single command
1
Sequence of commands
<pdu>
SIM Toolkit commands,
see GSM 11.14
Restriction:
The maximum PDU length is 176 bytes.
Unsolicited message
^SSTK:<data>