Specifications

AT command set for S45 Siemens mobile phones and modems
_________________________________________________________________________________________
__________________________________________________________________________________________
Siemens Document No.: A30880-A10-A001-3-D376
Revision: 1.8
Revision Date: 30. November, 2001
82
2.3.11.26 AT+FTS
AT+FTS Stop Transmission and Wait
Write command
AT+FTS=<time>
Used for FAX class 1 only
This command causes the TA to terminate a transmission and wait for <time>
10 millisecond intervals before responding with the OK result code to the DTE.
An ERROR response code results if this command is issued while the modem is
on-hook
Parameter
<time>
0 .. 85
number of 10 millisecond intervals
2.3.11.27 AT+FVRF
AT+FVRFC Vertical resolution format conversion
Test command
AT+FVRFC=?
Used for FAX class 2 only
This command determines the DCE response to a mismatch between the
vertical resolution negotiated for the facsimile session and the Phase C data
desired by the DTE.
An ERROR response code results if this command is issued while the modem
is on-hook
Response
(List of supported mismatch checking modes)
OK
Parameter
<vrfc>
0
disable mismatch checking
2
enable mismatch checking, with resolution conversion
of 1-D data in the DCE and an implied AT+FK
command executed on 2-D mismatch detection
Read command
AT+FVRFC?
Response
<vrfc>
OK
Parameter
<vrfc>
See Test command
Write command
AT+FVRFC=<vrfc>
Response
OK
Parameter
<vrfc>
See Test command
2.4 General commands according to ITU-T Recommendation V.25 ter
This section provides the descriptions of general ITU-T Recommendation V.25ter commands.
2.4.1.1 AT+GCAP
AT+GCAP Request Capabilities List
Test command
AT+GCAP=?
Response
OK/ERROR
Read command
AT+GCAP?
Response
+GCAP: <mode>
Parameter
<mode> : e.g. +CGSM,+FCLASS