Specifications

AT command set for S45 Siemens mobile phones and modems
__________________________________________________________________________________________
Siemens Document No.: A30880-A10-A001-3-D376
Revision: 1.8
Revision Date: 30. November.2001
77
2.3.11.12 AT+FDT
AT+FDT Data Transmission
Used for FAX class 2 only
This command requests the ME to transmit a Phase C page. When the ME
is ready to accept Phase C data, it issues the negotiation responses and
the CONNECT result code to the application.
In Phase B, this command releases the ME to proceed with negotiation,
and releases the DCS message to the remote station.
In Phase C, this command resumes transmission after the end of a data
stream transmitted before.
Execute command
AT+FDT
Parameter
<dt>
list of <DF>s, <VR>s, <WD>s, <LN>s
DF
Data compression Format
0
*
)
1-D modified Huffman
1 2-D modified read
2 2-D uncompressed mode
VR
Vertical Resolution
0
normal, 98 lpi
1
fine, 196 lpi
WD
Page Width
0
*
)
1728 pixels in 215mm
1 2048 pixels in 255 mm
2 2432 pixels in 303 mm
3 1216 pixels in 151 mm
4 864 pixels in 107 mm
LN
Page length
0 A4, 297mm
1 B4, 364mm
2 unlimited length
Response
CONNECT
2.3.11.13 AT+FET
AT+FET
End a page or document
Used for FAX class 2 only
This command indicates that the current page or part thereof is complete.
An ERROR response code results if this command is issued while the
mode is on-hook.
Write command
AT+FET=<ppm>
Parameter:
<ppm>
Post Page Message Codes
1
another document next
2
no more pages or documents
4
another page, procedure interrupt
5
another document, procedure interrupt
Response
OK/ERROR