Specifications

AT command set for S45 Siemens mobile phones and modems
_________________________________________________________________________________________
__________________________________________________________________________________________
Siemens Document No.: A30880-A10-A001-3-D376
Revision: 1.8
Revision Date: 30. November, 2001
70
2.3.11.2 AT+FBADMUL
AT+ FBADMUL
Define, read or test number of bad lines
Used for FAX class 2 only
This command defines the “Copy-Quality-OK” multiplier. The number of
lines received with a bad pixel count is multiplied by this number. If the
result exceeds the total number of lines on the page the error rate is
considered too high. A threshold multiplier value of 20 corresponds to a
5% error rate.
Read command
AT+ FBADMUL?
Response
Parameter
<n>
OK
Write command
AT+ FBADMUL =<n>
Parameter
<n>
0...255
0 indicates that error checking is present or
disabled
(Default value: 20)
2.3.11.3 AT+FBOR
AT+ FBOR
Query the bit order for receive mode
Used for FAX class 2 only
Query the bit order for receive-mode. The mode is set by the ME
dependent on the selected Service Class.
Test command
AT+FBOR=?
Response
+FBOR: (list of supported bit order modes <bor>s) OK
Parameter
<bor>
0 direct bit order for both Phase C and Phase B/D data
1 Reversed bit order for Phase C data, direct bit order for
Phase B/D data
Read command
AT+FBOR?
Response
Parameter
<bor>
OK
Write command
AT+FBOR=<bor>
Response
OK / ERROR
Parameter
<bor>
OK