Specifications

AT command set for S45 Siemens mobile phones and modems
__________________________________________________________________________________________
Siemens Document No.: A30880-A10-A001-3-D376
Revision: 1.8
Revision Date: 30. November.2001
69
0 e.g. TIA/EIA-602 or ITU V.25ter
1
Service Class 1
EIA/TIA-578-A
2 Vendor-specific this document and EIA PN-2388 (draft)
The following FAX commands are dummy commands. Invoking these commands will not cause ERROR result
codes, but these commands have no functionality either:
Command Meaning
AT+FAA Auto Answer mode
AT+FECM Error Correction Mode control
AT+FLNFC Page Length format conversion
AT+FLPL Indicate document available for polling
AT+FMINSP Minimum Phase C speed
AT+FRBC Phase C data receive byte count
AT+FREL Phase C received EOL alignment
AT+FSPL Enable polling
AT+FTBC Phase C data transmit byte count
AT+FWDFC Page width format conversion
Table 2-8: List of dummy FAX commands
2.3.11.1 AT+FBADLIN
AT+ FBADLIN
Define or read number of bad lines
Used for FAX class 2 only
This command defines the “Copy Quality OK” threshold.
If pixel count errors were detected in normal resolution (98 dpi) mode in
as many consecutive lines as defined in <badlin>, the copy quality is
unacceptable.
If pixel count errors were detected in fine resolution (196 dpi) mode in
twice as many consecutive lines as defined in <badlin>, the copy
quality is unacceptable.
“Copy Quality Not OK” occurs if either the error percentage is too high
or if too many consecutive lines contain errors
Read command
AT+ FBADLIN?
Response
<badlin> OK
Parameter
<badlin>
See Write command
Write command
AT+FBADLIN=<badlin>
Parameter
<badlin>
0...255
0 indicates that error checking is present or
disabled
(Default value: 10)