User Manual

7 / 12
Siemens RXL39.1 – Room controller CM2N3876en_10
Building Technologies 2015-12-23
Mounting
The room controllers can be mounted in any orientation, and fixed as follows:
80060
80061
Rail mounting
The housing base is designed for snap-
mounting on DIN rails, type EN50022-
35x7.5 (can be released with a screw-
driver)
Surface mounting
There are four drill holes for screw-
mounting (see “Dimensions” for drilling
template). The housing base is fitted with
raised supports.
When mounting note the following:
• The controller should not be freely accessible after mounting. It must be mounted
in a cabinet or behind a cover that can only be opened / removed with a key or a
tool.
• Ensure adequate air circulation to dissipate heat generated during operation.
• Easy access is required for service personnel
• Local installation regulations must be observed.
Mounting instructions and a drilling template are printed on the controller packaging.
Commissioning
The RXL39.1 room controller is commissioned with one of the following tools:
− Synco ACS via the OCI700 interface
− "HandyTool" via PPS2
The definitive application and the controller's location are handwritten in the
labeling fields "Appl." and "Loc" in the commissioning stage.
A special test mode (HandyTool) is available for operation of the outputs and
interrogation of the inputs.
Labeling
Function test