User Manual

59/90
Building Technologies Integration von DESIGO™ RXC in VISONIK CM2Z8338en_01
Building Automation Engineering 12.06.2006
4.7 Selecting the NIDES binding template
In the RXT10, select NIDES binding template VISONIK 1 or VISONIK 2.
To create user-defined templates, use the Binding Template Editor. The screenshot
shown is valid for the direction “Device to NIDES.R”:
X”.
Clicking the “Switch” button allows you to change direction (network variables from the
NIDES.RX to the device).
For general information on using the Binding Template Editor, refer to the manual for
the RXT10 commissioning and service tool.
User-defined templates can be created simply by basing them on the standard
templates and adding or removing individual bindings.
There are no standard templates for the integration of third-party devices.
The general procedure for integrating network variables is described in 4.11, Integration
of single parameters.
4.8 VISONIK data structures for integration
Template selection
User-defined templates
Notes