User Manual
5/90
Building Technologies Integration von DESIGO™RX in VISONIK CM2Z8338en_01
Building Automation About this document 12.06.2006
1 About this document
1.1 Overview
This opening section describes the content and purpose of this document. It
– Introduces the basic topology of the DESIGO RXC system within VISONIK
– Defines the target readership of this manual, and the background knowledge
required
– Shows how the activities described fit into the project handling procedure.
1
About this document .....................................................................................5
1.1 Overview.......................................................................................................5
1.2 Revision history ............................................................................................5
1.3 What is this document about?.......................................................................6
1.4 For whom is this document intended? ..........................................................7
1.5 What activities does this document describe?..............................................8
1.6 Related literature ..........................................................................................9
1.2 Revision history
All changes are marked by dots in the right margin.
06.2006 • Room operation via the Intranet not available any more (Section 2.7
• New entries to the mapping tables (Section 4.10)
10.2004 • Mapping tables 4.10.1 and 4.10.2: corrections and new entries
01.2004 • Revision of Section 3:
– 3.2.9 Room setpoint shift
– 3.2.10 Summer/winter compensation
– 3.2.21 Room temperature averaging
– Old subsection 3.6, Intranet room operation, replaced by new subsection 2.7.
– Old subsections 3.1.33 / 34, Single parameter integration / Third-party
inputs/outputs replaced by Tables 4.10.1 and 4.10.2.
• Section 4.10 Single parameter integration, new (Mapping tables 4.10.1 and 4.10.2).
11.2002 • Page 42: Numbering of the DP parameters for switches 2, 3 and 4 for blinds.
05.2002 • Major changes to Sections 4 and 5.
• Section 6 (SAPIM Code table) and 7 (diagnostics) have been revised and removed
to the Engineering Guide, Z8339.
Introduction
Contents of this section
.
.
.
.
.
.
.