User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
146 Adding a Remote Host
Figure 101: Remote Table
If remote hosts have not been configured, add hosts as needed. For more information, refer to Section 5.4.16.2,
“Adding a Remote Host”.
Section 5.4.16.2
Adding a Remote Host
To add a remote host for the Raw socket protocol, do the following:
1. Navigate to Serial Protocols » Configure Protocols » Configure Raw Socket » Configure Remote
Hosts. The Remote Hosts table appears.
Figure 102: Remote Table
2. Click InsertRecord. The Remote Hosts form appears.
6
4
5
1
2
3
Figure 103: Remote Hosts Form
1. IP Address Box 2. IP Port Box 3. Port(s) Box 4. Apply Button 5. Delete Button 6. Reload Button
3. Configure the following parameter(s) as required: