User guide

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Managing Raw Socket Remote Hosts 145
Parameter Description
• to place an outgoing connection or
• to place outgoing connection and wait for incoming (both directions).
Loc Port Synopsis: 1024 to 65535
Default: 50000
The local IP port to use when listening for an incoming connection.
Rem Port Synopsis: 1 to 65535
Default: 50000
The remote TCP port to use when placing an outgoing connection. This parameter is
applicable only to TCP transport.
IP Address Synopsis: ###.###.###.### where ### ranges from 0 to 255 or { }
Default:
For direction 'OUT' (client), remote IP address to use when placing an outgoing TCP
connection request. For direction 'IN' (server), local interface IP address to listen
to the local port for connection request. Empty string can be used for IP address of
management interface. For direction 'BOTH' (client or server), remote IP address to use
when placing an outgoing TCP connection requestListening interface will be chosen by
matching mask. This parameter is applicable only to TCP connections. If the transport
protocol is set to UDP, the remote port is configured using the "Remote Hosts" table.
Link Stats Synopsis: { Disabled, Enabled }
Default: Enabled
Enables links statistics collection for this protocol.
5. Click Apply.
Section 5.4.16
Managing Raw Socket Remote Hosts
The following sections describe how to configure and manage remote hosts:
• Section 5.4.16.1, “Viewing a List of Remote Hosts”
• Section 5.4.16.2, “Adding a Remote Host”
• Section 5.4.16.3, “Deleting a Remote Host”
Section 5.4.16.1
Viewing a List of Remote Hosts
To view a list of remote hosts configured for the Raw socket protocol, navigate to Serial Protocols » Configure
Protocols » Configure Raw Socket » Configure Remote Hosts. The Remote table appears.