User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
144 Configuring the Telnet Com Port Protocol
12
11
1
2
3
4
5
6
7
8
9
10
Figure 100: Telnet Com Port Form
1. Port Box 2. Pack Char Box 3. Pack Timer Box 4. Pack Size Box 5. Flow Control Options 6. Call Dir List 7. Loc Port
Box 8. Rem Port Box 9. IP Address Box 10. Link Stats Options 11. Apply Button 12. Reload Button
4. Configure the following parameter(s) as required:
Parameter Description
Port Synopsis: 1 to maximum port number
Default: 1
The serial port number as seen on the front plate silkscreen of the RMC30.
Pack Char Synopsis: 0 to 255 or { Off }
Default: Off
The character that will be used to force the forwarding of buffered data to the network. If
a packetization character is not configured, buffered data will be forwarded based upon
the packetization timeout (Pack Timer) parameter.
Pack Timer Synopsis: 1 to 1000
Default: 10 ms
The delay from the last received character until when data is forwarded. If parameter
value is set to be less than 3 ms, there is not guaranty that it will be obeyed. It will be a
minimum possible time in which device can react under certain data load.
Pack Size Synopsis: 16 to 1400 or { Maximum }
Default: Maximum
The maximum number of bytes received from serial port to be forwarded.
Flow Control Synopsis: { None, XON/XOFF }
Default: None
The Flowcontrol setting for serial port.
Call Dir Synopsis: { In, Out, Both }
Default: In
The Call direction for TCP Transport.
• Whether to accept an incoming connection or