User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
142 Configuring the Mirrored Bits Protocol
Figure 97: Mirrored Bits Table
3. Select a serial port. The Mirrored Bits form appears.
8
7
3
4
5
6
1
2
Figure 98: Mirrored Bits Form
1. Port Box 2. Transport Box 3. Loc Port Box 4. Rem Port Box 5. IP Address Box 6. Link Stats Options 7. Apply Button
8. Reload Button
4. Configure the following parameter(s) as required:
Parameter Description
Port Synopsis: 1 to 4
Default: 1
The port number as seen on the front plate silkscreen of the switch.
Transport Synopsis: { TCP, UDP }
Default: UDP
The network transport used to transport Mirrored Bits protocol data over an IP network.
Loc Port Synopsis: 1 to 65535
Default: 61001
The local IP port to use when listening for an incoming connection or UDP data.
Rem Port Synopsis: 1 to 65535
Default: 61000
The remote TCP port to use when placing an outgoing connection.
IP Address Synopsis: ###.###.###.### where ### ranges from 0 to 255 or { <EMPTY STRING> }
Default:
For an outgoing TCP connection (client) and UDP transport, this is the remote IP
address to communicate with.