User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
140 Configuring the DNP Over Raw Socket Protocol
Section 5.4.13
Configuring the DNP Over Raw Socket Protocol
To configure the DNP Over Raw Socket protocol for a serial port, do the following:
1. Make sure the serial port is configured to use the DNP Over Raw Socket protocol. For more information,
refer to Section 5.4.5, “Configuring a Serial Port”.
2. Navigate to Serial Protocols » Configure Protocols » Configure DNP Protocol » Configure DNP over
RawSocket. The DNP over RawSocket table appears.
Figure 95: DNP over RawSocket Table
3. Select a serial port. The DNP over RawSocket form appears.
10
9
1
2
3
4
5
6
8
7
Figure 96: DNP over RawSocket Form
1. Port Box 2. Transport Options 3. Call Dir List 4. Max Conns Box 5. Loc Port Box 6. Rem Port Box 7. IP Address Box
8. Link Stats Options 9. Apply Button 10. Reload Button
4. Configure the following parameter(s) as required:
Parameter Description
Port Synopsis: 1 to 4
Default: 1
The port number as seen on the front plate silkscreen on the switch.
Transport Synopsis: { TCP, UDP }
Default: TCP
The network transport used to transport protocol data over the IP network.
Call Dir Synopsis: { In, Out, Both }