User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
132 Configuring the Preemptive Raw Socket Protocol
14
13
1
10
6
2
5
11
8
3
7
12
9
4
Figure 88: Preemptive Raw Socket Form
1. Port Box 2. Pack Char Box 3. Pack Timer Box 4. Pack Size Box 5. Flow Control Options 6. Loc Port Box 7. Rem Port
Box 8. IP Address Box 9. Link Stats Options 10. Dyn Pack Char Box 11. Dyn Pack Timer Box 12. Timeout Box 13. Apply
Button 14. Reload Button
4. Configure the following parameter(s) as required:
Parameter Description
Pack Size Synopsis: 16 to 1400 or { Maximum }
Default: Maximum
The maximum number of bytes received from serial port to be forwarded.
Dyn Pack Char Synopsis: 0 to 255 or { Off }
Default: Off
The character that can be used to force forwarding of accumulated data to the network
for connection to dynamic master.If a packetization character is not configured,
accumulated data will be forwarded based upon the packetization timeout parameter.
Loc Port Synopsis: 1 to 65535
Default: 62001
The local IP port to use when listening for an incoming connection or UDP data.
Rem Port Synopsis: 1 to 65535
Default: 62000
The remote TCP port to use when placing an outgoing connection.
Port Default: 1
The port number as seen on the front plate silkscreen of the switch.
Pack Char Synopsis: 0 to 255 or { Off }
Default: Off