User guide

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Configuring the Preemptive Raw Socket Protocol 131
Parameter Description
Enables link statistics collection for the protocol.
5. Click Apply.
6. Add one or more remote hosts. For more information, refer to Section 5.4.16.2, “Adding a Remote Host”.
Section 5.4.7
Configuring the Preemptive Raw Socket Protocol
To configure the Preemptive Raw Socket protocol for a serial port, do the following:
1. Make sure the serial port is configured to use the Preemptive Raw Socket protocol. For more information,
refer to Section 5.4.5, “Configuring a Serial Port”.
2. Navigate to Serial Protocols » Configure Protocols » Configure Preemptive Raw Socket. The
Preemptive Raw Socket table appears.
Figure 87: Preemptive Raw Socket Table
3. Select a serial port. The Preemptive Raw Socket form appears.