User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
130 Configuring the Raw Socket Protocol
Parameter Description
Default: 1
The port number as seen on the front plate silkscreen of the switch.
Pack Char Synopsis: 0 to 255 or { Off }
Default: Off
The character that can be used to force forwarding of accumulated data to the network.
If a packetization character is not configured, accumulated data will be forwarded based
upon the packetization timeout (Pack Timer) parameter.
Pack Timer Synopsis: 3 to 1000
Default: 10 ms
The delay from the last received character until when data is forwarded.
Pack Size Synopsis: 64 to 1400 or { Maximum }
Default: Maximum
The maximum number of bytes received from the serial port to be forwarded.
Flow Control Synopsis: { None, XON/XOFF }
Default: None
The Flowcontrol setting for serial port.
Transport Synopsis: { TCP, UDP }
Default: TCP
The network transport used to transport protocol data over IP network.
Call Dir Synopsis: { In, Out, Both }
Default: In
The Call direction for TCP Tranport.
• Whether to accept an incoming connection or
• to place an outgoing connection or
• to place outgoing connection and wait for incomming (both directions).
Max Conns Synopsis: 1 to 64
Default: 1
The maximum number of allowed incoming TCP connections (for configurations using
TCP).
Loc Port Synopsis: 1024 to 65535
Default: 50000
The local IP port to use when listening for an incoming connection or UDP data.
Rem Port Synopsis: 1 to 65535
Default: 50000
The remote TCP port to use when placing an outgoing connection. Note that this
parameter is applicable only to TCP connections. If the transport protocol is set to UDP,
the remote port is configured using the "Remote Hosts" table.
IP Address Synopsis: ###.###.###.### where ### ranges from 0 to 255 or { }
For direction: 'Out' (client), the remote IP address to use when placing an outgoing TCP
connection request.
For direction: 'In' (server), the local interface IP address on which to listen for connection
requests. An empty string implies the default: the IP address of the management
interface.
For direction: 'Both' (client or server), the remote IP address to use when placing an
outgoing TCP connection request. The listening interface will be chosen by matching
mask. Note that this parameter is applicable only to TCP connections. If the transport
protocol is set to UDP, the remote port is configured using the "Remote Hosts" table.
Link Stats Synopsis: { Disabled, Enabled }
Default: Enabled