User guide

RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Configuring the Raw Socket Protocol 129
Section 5.4.6
Configuring the Raw Socket Protocol
To configure the Raw Socket protocol for a serial port, do the following:
1. Make sure the serial port is configured to use the Raw Socket protocol. For more information, refer to
Section 5.4.5, “Configuring a Serial Port”.
2. Navigate to Serial Protocols » Configure Protocols » Configure Raw Socket » Configure Protocol. The
Protocol table appears.
Figure 85: Protocol Table
3. Select a serial port. The Protocol form appears.
14
13
12
11
10
5
4
3
2
9
8
7
6
1
Figure 86: Protocol Form
1. Port Box 2. Pack Char Box 3. Pack Timer Box 4. Pack Size Box 5. Flow Control Options 6. Transport Options 7. Call Dir
List 8. Max Conns Box 9. Loc Port Box 10. Rem Port Box 11. IP Address Box 12. Link Stats Options 13. Apply Button
14. Reload Button
4. Configure the following parameter(s) as required:
Parameter Description
Port Synopsis: 1 to maximum port number