User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
110 Deleting an SNMP Group
Section 5.2.3.3
Deleting an SNMP Group
To delete an SNMP group, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Access. The SNMP Access table
appears.
Figure 72: SNMP Access Table
2. Select the group from the table. The SNMP Access form appears.
9
7
8
6
5
4
3
2
1
Figure 73: SNMP Access Form
1. Group Box 2. Security Model Box 3. Security Level Box 4. ReadViewName Box 5. WriteViewName Box
6. NotifyViewName Box 7. Apply Button 8. Delete Button 9. Reload Button
3. Click Delete.
Section 5.3
Managing Network Discovery
ROS supports the RUGGEDCOM Discovery Protocol (RCDP), a Layer 2 protocol for automated network
discovery.
RUGGEDCOM Discovery Protocol (RCDP) supports the deployment of ROS -based devices that have not been
configured since leaving the factory. ROS devices that have not been configured all have the default IP (Layer 3)
address. Connecting more than one of them on a Layer 2 network means that one cannot use standard IP-based