Manualshelf

User guide

ManualsBrandsSiemens ManualsComputer equipmentRUGGEDCOM RSG2200
111112113114115116117118119120
RUGGEDCOM ROS
User Guide
Chapter 5
Setup and Configuration
Managing Security-to-Group Mapping 105
Section 5.2.2
Managing Security-to-Group Mapping
The following sections describe how to configure and manage security-to-group maps, refer to the following:
• Section 5.2.2.1, “Viewing a List of Security-to-Group Maps”
• Section 5.2.2.2, “Adding a Security-to-Group Map”
• Section 5.2.2.3, “Deleting a Security-to-Group Map”
Section 5.2.2.1
Viewing a List of Security-to-Group Maps
To view a list of security-to-group maps configured on the device, navigate to Administration » Configure
SNMP » Configure SNMP Security to Group Maps. The SNMP Security to Group Maps table appears.
Figure 64: SNMP Security to Group Maps Table
If security-to-group maps have not been configured, add maps as needed. For more information, refer to
Section 5.2.2.2, “Adding a Security-to-Group Map”.
Section 5.2.2.2
Adding a Security-to-Group Map
Multiple combinations of security models and groups can be mapped (up to a maximum of 32) for SNMP.
To add a security-to-group map, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Security to Group Maps. The SNMP
Security to Group Maps table appears.