User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
168 Managing SNMP Users
Section 5.7.1
Managing SNMP Users
The following sections describe how to configure and manage SNMP users, refer to the following:
• Section 5.7.1.1, “Viewing a List of SNMP Users”
• Section 5.7.1.2, “Adding an SNMP User”
• Section 5.7.1.3, “Deleting an SNMP User”
Section 5.7.1.1
Viewing a List of SNMP Users
To view a list of SNMP users configured on the device, navigate to Administration » Configure SNMP »
Configure SNMP Users. The SNMP Users table appears.
Figure 121: SNMP Users Table
If users have not been configured, add users as needed. For more information, refer to Section 5.7.1.2, “Adding
an SNMP User”.
Section 5.7.1.2
Adding an SNMP User
Multiple users (up to a maximum of 32) can be configured for the local SNMPv3 engine, as well as SNMPv1 and
SNMPv2c communities.
NOTE
When employing the SNMPv1 or SNMPv2c security level, the User Name parameter maps the
community name with the security group and access level.
To add a new SNMP user, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Users. The SNMP Users table
appears.