User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
132 Deleting a Static VLAN
Parameter Description
The VLAN Identifier is used to identify the VLAN in tagged Ethernet frames according to
IEEE 802.1Q.
VLAN Name Synopsis: Any 19 characters
The VLAN name provides a description of the VLAN purpose (for example, Engineering
VLAN).
Forbidden Ports Synopsis: Any combination of numbers valid for this parameter
These are ports that are not allowed to be members of the VLAN.
Examples:
• None - all ports of the switch are allowed to be members of the VLAN
• 2,4-6,8 - all ports except ports 2, 4, 6, 7 and 8 are allowed to be members of the
VLAN
IGMP Synopsis: { Off, On }
Default: Off
This parameter enables or disables IGMP Snooping on the VLAN.
MSTI Synopsis: 0 to 16
Default: 0
This parameter is only valid for Multiple Spanning Tree Protocol (MSTP) and has no
effect if MSTP is not used. The parameter specifies the Multiple Spanning Tree Instance
(MSTI) to which the VLAN should be mapped.
4. Click Apply.
Section 5.2.5.3
Deleting a Static VLAN
To delete a static VLAN, do the following:
1. Navigate to Virtual LANs » Configure Static VLANs. The Static VLANs table appears.
Figure 88: Static VLANs Table
2. Select the static VLAN from the table. The Static VLANs form appears.