User guide

Chapter 5
Setup and Configuration
RUGGEDCOM ROS
User Guide
130 Managing Static VLANs
Parameter Description
• ADVERTISE ONLY - the port will declare all VLANs existing in the switch (configured
or learned) but will not learn any VLANs.
• ADVERTISE & LEARN - the port will declare all VLANs existing in the switch
(configured or learned) and can dynamically learn VLANs.
Only Trunk ports are GVRP-capable.
4. Click Apply.
Section 5.2.5
Managing Static VLANs
The following sections describe how to configure and manage static VLANs:
• Section 5.2.5.1, “Viewing a List of Static VLANs”
• Section 5.2.5.2, “Adding a Static VLAN”
• Section 5.2.5.3, “Deleting a Static VLAN”
Section 5.2.5.1
Viewing a List of Static VLANs
To view a list of static VLANs, navigate to Virtual LANs » Configure Static VLANs. The Static VLANs table
appears.
Figure 85: Static VLANs Table
If a static VLAN is not listed, add the VLAN. For more information, refer to Section 5.2.5.2, “Adding a Static
VLAN”.
Section 5.2.5.2
Adding a Static VLAN
To add a static VLAN, do the following:
1. Navigate to Virtual LANs » Configure Static VLANs. The Static VLANs table appears.