Specifications

Chapter 4
Technical Specifications
RUGGEDCOM RS8000
Installation Guide
16 Copper Ethernet Port Specifications
Section 4.3
Copper Ethernet Port Specifications
The following details the specifications for copper Ethernet ports that can be ordered with the RS8000.
Speed
e
Connector Duplex
e
Cable Type
f
Wiring Standard
g
Maximum Distance
h
Isolation
i
10/100Base-TX RJ45 FDX/HDX > Category 5 TIA/EIA T568A/B 100 m (328 ft) 1.5 kV
e
Auto-negotiating.
f
Shielded or unshielded.
g
Auto-crossover and auto-polarity.
h
Typical distance. Dependent on the number of connectors and splices.
i
RMS 1 minute.
Section 4.4
Fiber Optic Ethernet Port Specifications
The following details fiber optic specifications for ports that can be equipped on the RS8000 . The user
determines the type of optics at the time of ordering, and can determine the ports installed on a particular unit by
reading the factory data file via the ROS user interface. The specifications are organized by order code. Module
order codes are contained within each unit when it is assembled and configured at the factory. For information
about obtaining factory configuration data, refer to the ROS User Guide for the RS8000.
Mode
j
Connector
Type
Cable
Type (μm)
Tx λ (typ.)
(nm)
Tx min.
(dBm)
Tx max.
(dBm)
Rx
Sensitivity
(dBm)
Rx
Saturation
(dBm)
Distance
(typ.) (km)
Power
Budget
(dB)
MM MTRJ 50/125 1310 -16 -11 -33.5 -11 2 17
SM LC 9/125 1310 -15 -8 -31 -5 15 16.5
j
MM = Multi-Mode, SM = Single-Mode
Section 4.5
Operating Environment
Parameter Range Comments
Ambient Operating Temperature -40 to 85°C Ambient Temperature as measured from a
30 cm radius surrounding the center of the
enclosure.
Ambient Relative Humidity 5% to 95% Non-condensing
Ambient Storage Temperature -40 to 85°C