Technical data

Installation

4.1 Installing and uninstalling the RS 485 repeater

RS 485 Repeater

Manual, 02/2011, A5E03382072-01

Installation on a standard mounting rail

To be able to install the repeater on a standard mounting rail, the catch must be present on

the rear of the RS 485 repeater:

1. Fit the RS 485 repeater into the standard mounting rail from above and

2. Push it towards the back until the catch locks it in place.

Removal from the standard mounting rail

To remove the RS 485 repeater from the standard mounting rail:

1. Press down the catch on the bottom of the RS 485 repeater using a screwdriver and

2. Pull the RS 485 repeater upwards and out to remove it from the standard mounting rail.