Technical data
Description
3.2 Design of the RS 485 repeater
RS 485 Repeater
Manual, 02/2011, A5E03382072-01
11
3.2 Design of the RS 485 repeater
The following table shows the design and functions of the RS 485 repeater.
Table 3- 3 Design and functions of the RS 485 repeater
Design of the repeater no. Function
①
Connection for the RS 485 repeater power supply (pin "M5.2" is the
ground reference, if you want to measure the voltage difference
between terminals "A2" and "B2").
②
Shield clamp for the strain relief and grounding of the bus cable of bus
segments 1 or 2
③
Terminals for the bus cable of bus segment 1
④
Switches for terminating resistance for bus segment 1
⑤
LED for bus segment 1
⑥
OFF switch
(= isolate bus segments from each other, for example, for
commissioning)
⑦
LED for bus segment 2
⑧
Switches for terminating resistance for bus segment 2
⑨
LED 24 V supply voltage
⑩
Terminals for the bus cable of bus segment 2
⑪
Slide for mounting and removing the RS 485 repeater on the standard
mounting rail
/
$
21
21
2))
'3
6
6
'3
02'(
'&9
3*
23
56
5(3($7(5
(6
$$;$
;
% $ %
$ % $ %
03(0
s
⑫
Interface for PG/OP on bus segment 1
Note
Terminal M 5.2 of the power supply serves as ground reference for signal measurements in
the event of a fault and should not be wired.