Technical data

Installation instructions and notes on usage
D.1 Fitting connectors to SIMATIC NET PCF fiber-optic cables with the simplex 6GK1 900-0KL00-0AA0 termination kit
PROFIBUS Network Manual
System Manual, Edition 04/2009, C79000-G8976-C124-03
281
8. Remove the loose core sleeve with your hand.
9. Cut back the Kevlar with the Kevlar scissors leaving
5 mm and fold it back uniformly over the core jacket.
10. Push the anti-kink sleeve over the fiber
and the core jacket.
If you want to use the connector adapter (see description
below), you do not need to use the anti-kink sleeve.
11. Push the crimp ring over the fiber and screw it
onto the jacket.
12. Insert the crimp ring in the front recess of the
crimping pliers and close the pliers.
13. Cut into the buffer with pliers opening ø 0.3 mm
and pull off the buffer without skewing.
Approximately 5 mm of the buffer remain.
14. Push the ferrule over the fiber and insert this into the
crimp ring.