Basic Documentation

185/256
Siemens Modular Heating Controller RMH760B CE1P3133en
Building Technologies 11 Logic functions 2017-09-29
If a terminal in another functions should be also used (e.g. heating circuit 1…3), it must
be configured first with this function. This means, the use of the terminal depends on
the order of the configuration.
In order to be able to set all configuration and setting options with different units, the
ACS790 has a "help menu" input identifier.
RMH760 > Commissioning > Extra configuration > Input identifier
This menu point is only available with ACS790. This means, this menu point does not
exist in the controller.
For example, in a Logic block (Logic 1…4) is “ppm“ used as measurement. Therefore, it
must be ensured that the unit “ppm“ is defined in the help menu input identifier
(example above N.X3 = ppm).
It is mandatory, that the unit "ppm" must be set with the setting for the Display input of
the function block respectively be the same (example below with Display input 1).
Important information
for
setting/operation with
ACS790