Data Sheet for Product

12 / 16
Siemens REV24.. room temperature controller CE1N2205en
Smart Infrastructure 2019-07-17
· Remove from the batteries the battery transit tab designed to prevent premature
activation of the unit: Select desired language by or . Confirm by .
· You can change the control characteristics using the DIP switch on the rear of the unit
· Set any thermostatic radiator valves to their fully open position, if present in the
reference room
· Recalibrate the temperature sensor (see "Sensor calibration") if the displayed room
temperature does not match the room temperature measured
This is a software class A controller designed for use at a normal degree of pollution.
Disposal
The device is considered electrical and electronic equipment for disposal in terms of
the applicable European Directive and may not be disposed of as domestic garbage.
· Dispose of the device through channels provided for this purpose.
· Comply with all local and currently applicable laws and regulations.
· Dispose of empty batteries in designated collection points.
WARNING
Risk of explosion due to fire or short-circuit, even if the batteries are empty
Risk of injuries from by flying parts
● Do not allow the batteries to come into contact with water.
● Do not charge the batteries.
● Do not damage or destroy the batteries.
●
Do not heat the batteries to more than 85
°
C.
WARNING
Electrolyte leakage
Chemical burns
● Only grasp damaged batteries using suitable protective gloves.
● If electrolyte comes into contact with eyes, immediately rinse eyes with plenty of
water. Consult a doctor.
Observe the following:
· Only replace batteries with batteries of the same type and from the same manufacturer.
· Observe the polarities (+/-).
· The batteries must be new and free from damage.
· Do not mixed new batteries with used batteries.
· Store, transport, and dispose of the batteries in accordance with local regulations, guidelines, and laws. Also
observe information from the battery manufacturer.
Commissioning
Notes