Technical data
8/15
Building Technologies REV200…RF room temperature controller CE1N2214en
HVAC Products 28.08.2008
• If the room temperature displayed does not agree with the room temperature
effectively measured, the temperature sensor should be recalibrated
(refer to « Sensors Calibration » page 4).
• The unit can be fitted to most commercially available recessed conduit boxes or
directly on the wall
• Mounting height is approximately 1.5 m above the floor
• When installing the controller, the base must first be fitted. Then, the unit can be
engaged at the top, swung downward and snapped on
• For more detailed information, refer to the installation instructions supplied with the
unit
• In the case of wall mounting, ensure that there is sufficient clearance for removing the
controller from its base, and for replacing it
min.
10 cm
2261Z03
• Refer to the Installation Instructions printed on the package.
• The receiver and switching unit should preferably be mounted near the controlled
device
• The unit should be located such that it can receive signals with as little interference
as possible. For this reason, the following points should be observed (same as with
the transmitter):
− Not in control panels
− Not on metal surfaces
− Not in the vicinity of electrical cables and equipment such as PCs, TV sets,
microwave appliances, etc.
− Not in the vicinity of large metal structures or construction elements with fine
metal meshes like special glass or special concrete
• The location where the unit is mounted should be dry and free from splash water
• The unit can be fitted to most commercially available recessed conduit boxes or
directly on the wall
The receiver must be wired with the power supply switched off.
Mains voltage may be switched on again only after the unit is completely
mounted.
• When mounting the unit, the base must first be fitted and wired (L/N = AC 230 V
mains supply, LX/L1 = consumers). Then, engage the unit at the top, swing it
downward and secure it with a screw
• For more detailed information, refer to the Installation Instructions supplied with the
unit
For the electrical installation, the local safety regulations must be complied with.
Wall mounting of
controller / transmitter
REV200.03RF
REV200S.03RF
Support of REV200…
Planning Receiver
REV-R.03/1
REV-R.03S/1
Mounting and
installation of receiver
REV-R.03/1
REV-R.03S/1