User Manual

Document No. 125-1009
Installation Instructions
April 27, 2020
Siemens Industry, Inc. Page 19 of 21
Table 15. Suggested Sensors for Use with RDY2000BN.
Siemens Part
Number
Description
Signal Format
QAA2330.EWNN
Remote Wall-Mounted Sensor – Temperature Only
10K Ohm, Type II NTC
QFA33SS.EWNN
Remote Wall-Mounted Temperature and Humidity Sensor
0-10V
QAM2030.010
Duct-Mounted Temperature Sensor
10K Ohm, Type II NTC
QFM2160U
Duct-Mounted Temperature & Humidity Sensor
0-10V
QPA2000
Wall-Mounted CO2 Sensor
0-10V
QPA2062
Wall-Mounted Temperature + Humidity + CO2 Sensor
0-10V
QPM2162
Duct-Mounted Temperature + Humidity + CO2 Sensor
0-10V
QAC2030
Outdoor Air Temperature Sensor
10K Ohm, Type II NTC
QAD2030
Surface-Mount Pipe Temperature Sensor
10K Ohm, Type II NTC
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and the receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Modifications
This device complies with Part 15 of the FCC rules and IC rules. Changes or modifications not expressly approved by Siemens Industry Inc. could void
the user’s authority to operate the equipment.
Industry Canada
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
CAN ICES-3 (B)/NMB-3 (B)
Limited Warranty
Siemens Product Guard Warranty warrants the purchased from it or its authorized reseller to be free from defects in material and workmanship under
normal use during the two-year period commencing on the date of purchase. The written proof of purchase is required for such warranty period to apply.
The software included in this Siemens product is licensed for use subject to the Siemens end-user license agreement (“EULA”) posted at
www.usa.siemens.com/btcpseula (Siemens’ EULA web site) for this software identified by product model or part number on the Siemens EULA web site.