User Manual

Changing system setup
5
16 | 30 A6V11214854_enUS_a
*) If 0 to 10 V is selected as the signal type, a DC 0 to10 V active sensor must be
connected with the thermostat. Otherwise, the calculated value may not be accurate.
To change the extended configurations
1. On the Advanced Settings page, tap .
2. If prompted, enter the administrator password.
3. Tap and then tap .
4. Tap OK to stop all the thermostat’s applications. The thermostat restarts.
5. After the restart is completed, tap I/O and then tap Adapt.
6. Change the settings as desired.
You can reset the thermostat to its original factory settings. However, all user data will
be erased after the factory resetting.
To perform a factory reset
1. On the Advanced Settings page, tap .
2. If prompted, enter the administrator password.
3. Tap > .
4. Tap OK to stop all of the thermostat’s applications. The thermostat restarts.
5. After the restart is completed, tap Factory Reset.
6. Tap Reset. The thermostat is reset and restarted.
NOTE: After the thermostat is restarted, the setup wizard appears for easy
commissioning. Refer to the Quick guide for the detailed setup information.
Resetting the thermostat