Commissioning Instructions

Changing system setup
5
A6V11214854_enUS_c
15 | 61
*) If 0 to 10 V is selected as the signal type, a DC 0 to10 V active sensor must be
connected with the thermostat. Otherwise, the calculated value may not be
accurate.
To change the extended configurations
1. On the Advanced Settings page, tap .
2. If prompted, enter the administrator password.
3. Tap and then tap .
4. Tap OK to stop all the thermostat’s applications. The thermostat restarts.
5. After the restart is completed, tap I/O and then tap Adapt.
6. Change the settings as desired.
You can reset the thermostat to its original factory settings. However, all user data
but the association with mobile application accounts will be erased after factory
resetting. Note that though the thermostat is still associated with the original
account after the factory resetting, its connection status in the mobile application
shows as offline until the thermostat connects to a network successfully.
To perform a factory reset
1. On the Advanced Settings page, tap .
2. If prompted, enter the administrator password.
3. Tap > .
4. Tap OK to stop all of the thermostat’s applications. The thermostat restarts.
5. After the restart is completed, tap Factory Reset.
6. Tap Reset. The thermostat is reset and restarted.
NOTE: After the thermostat is restarted, the setup wizard appears for easy
commissioning. Refer to the Quick guide for the detailed setup information.
Resetting the thermostat