User Manual

Abo
ut this document
Target audience, prerequisites
1
A6V11545892_en--_a 7 | 146
1.4 Target audience, prerequisites
This document assumes that users of the RDG2..KN room thermostats are familiar
with the ETS tool, Synco ACS tool or both and can use them.
It is also assumed that these users are aware of the specific conditions associated
with KNX.
In most countries, specific KNX know-how is conveyed through training centers
certified by the KNX Association (see www.knx.org/).
For reference documentation, see Reference documents [➙ 5].
1.5 Glossary
The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this document:
Parameters identified by this symbol are set using ETS.
Parameters identified by this symbol are set using ACS.
Note!
Setting RDG2..KN KNX parameters is only supported by the
following tool versions:
● ETS5 or higher versions
● ACS version 5.11 and version 8.32 or higher
Inputs and outputs identified by this symbol communicate with
other KNX devices.
They are called communication objects (CO).
The communication objects of the RDG2..KN works partly in S-
Mode, partly in LTE-Mode, and partly in both. These objects are
described accordingly.
A list of the parameters is shown in Control parameters [➙ 104].