User Manual
Table Of Contents
- 1 About this document
- 2 Overview
- 3 Notes
- 4 Functions
- 4.1 Temperature control
- 4.2 Operating modes
- 4.3 Room temperature setpoints
- 4.4 Application overview
- 4.5 Power supply selection for RDG200KN
- 4.6 Additional functions
- 4.7 Control sequences
- 4.7.1 Sequence overview (setting via P001)
- 4.7.2 Application mode
- 4.7.3 2-pipe fan coil unit
- 4.7.4 2-pipe fan coil unit with electric heater
- 4.7.5 2-pipe fan coil unit with radiator or floor heating
- 4.7.6 2-pipe/2-stage heating or cooling
- 4.7.7 4-pipe fan coil unit
- 4.7.8 4-pipe fan coil unit with electric heater
- 4.7.9 Chilled/heated ceiling and radiator applications
- 4.7.10 Compressor applications
- 4.7.11 Applications with external AQR sensor or QMX room operator unit
- 4.7.12 Setpoints and sequences
- 4.8 Control outputs
- 4.9 Fan control
- 4.10 Multifunctional input, digital input
- 4.11 Handling system faults
- 4.12 KNX communications
- 4.13 Communication objects (S-Mode)
- 4.14 Communication objects (LTE-Mode)
- 4.15 Control parameters
- 5 Supported KNX tools
- 6 Connection
- 7 Technical data
- 8 Dimensions
- Index /
Supported KNX tools
ACS tool
5
122 | 150 A6V11545892_en--_a
5.2.1 Setting parameters in ACS
In the ACS program, select Plant ➙ Open to open the plant.
To open the parameter settings, select Applications ➙ Plant engineering.
The application and control parameters can be adjusted and downloaded.
Line no. contains the parameter number as displayed in the parameter table. See
Control parameters [➙ 108].
Some parameters in ACS have a range different from that on the room
thermostats.
The thermostat does not accept changes outside its range. This can be seen
online in that a changed value returns to the original value.
Use the ranges described in the parameter tables in Control parameters [➙ 108].
Note!